SS 10 SHOWER SEAL

LEAKAGE PREVENTION, PROTECT AND EXTEND DURABILITY OF WATERPROOFING SYSTEM, STOP LEAKING TOILETS WITHOUT REMOVING TILES

BUY NOW ON 

LAZADA MALL

 

 

 

 

 

 

 

 

 

→ See performance of WARRIOR SS 10 SHOWER SEAL on YouTube

 

USES

• To prevent water leakage
• To provide protection to the existing waterproofing system and to extend its durability
• To stop water leakage without needing to remove the existing tiles
• To reduce water absorption of both interior and exterior wall, tiles, stone, granite, marbles and cement surfaces.

 

FEATURES

• SS10 is a ready-to-use aqueous silicone ester emulsion.
• SS10 provides long lasting sub-surface protection and does not change the surface appearance.
• SS10 does not form film on surface, thus eliminating the wearing off issue over times.
• SS10 has high surface colour stability, leaving minimal surface appearance changes.
• SS10 is easy to use: simply by spray or brush.

 

 

APPLICATION METHODS

TOILET

1. Ensure surface to be treated is clean and intact. It should be free from bitumen, oil, grease and loose particles. All the cracked and defective tile joints must be removed.
2. Allow the toilet to dry for 1 day before application.
3. Apply SS10 generously by brush or by spray, onto the entire wall and floor tile joints, edges of toilet bowls and nailing point of shower screen.
4. After one hour, apply second coat of SS10.
5. After one hour, patch back the defects on tile joints (if necessary, using tile grout added with W1 Cement Strengthener).
6. Allow one day for the treatment to dry and cure.
7. Job done.

Remark:

• SS10 is to be absorbed into the substrate. Do not apply SS10 on non-absorbent surfaces, such as glass, aluminium, etc.
• Wipe away excessive SS10 on surface after 30 minutes of application. Do not allow a thick patch of SS10 to air dry on the surface as it may cause unwanted surface stain.
• Always conduct a patch test, by applying SS10 on a remote corner of the toilet. After 24 hours, check for any unwanted surface appearance changes. Carry out full application only when no surface change is visible.

 

Physical Form
White liquid with slight alcoholic odour.

Coverage
Approx 30 sq. ft /kg depending upon the porosity of the Substrate

 

PACKING

500 ml-bottle / 1 L-bottle

 

BUY NOW ON

LAZADA MALL

shopee

            

DOWNLOAD CATALOGUE in PDF (Right Click–Save As)

Disclaimer: The information provided in this brochure is ensured to be as accurate as possible at the time of inclusion, however there may be inadvertent and occasional errors which may have slipped from our notice. Warrior Pte Ltd does not guarantee and make no representations or warranties of any kind about the information, advice and opinions provided and reserves the right to make changes and corrections at any time, without prior notice to any parties. Warrior Pte Ltd accepts no liability for any inaccuracies or omissions in its brochure and any decisions made based on information and opinions contained in the bro-chure is the sole responsibility of the user.